Stud Wall Section

An exterior wall must be properly layered to ensure longevity and remain structurally sound while keeping moisture out and heat in.

Stud wall section. Wood stud partitions with framing 16 o c. Cripple stud a stud located either above or below a framed opening that does not run the full height of the wall. A metal stud is ductile and therefore can perform at a wide range of deflections.

Interior nonbearing walls shall be permitted to be con structed with 2 inch by 3 inch 51 mm by 76 mm studs spaced24inches 610mm oncenteror whennotpartof abracedwallline 2 inch by 4 inch 51mmby102mm flat studs spaced at 16 inches 406 mm on center. 39a firestoppingof masonry walls floor. Any stud may be bored or drilled provided that the diameter of the resulting hole is no more than 60 percent of the stud width the edge of the hole is no more than 5 8 inch 16 mm to the edge of the stud and the hole is not located in the same section as a cut or notch.

The last section in the above illustration showcases the various layers in an exterior wall. Exterior walls shall provide the building with a weather resistant exterior wall envelope. Ceiling attenuation class of gridstone ceiling.

Trimmer or jack stud to the left or right of a window or door that runs from the bottom plate to the underside of a lintel or header. Inte rior nonbearing walls shall be capped with at least a sin gle top plate. Steel stud partitions with framing 16 o c.

The provisions of this section shall apply to exterior walls wall coverings and components thereof. A wall is a collection of studs usually sized 2 4 or 2 6 equally spaced usually 16 in. Post or column a doubled or other integral multiple of a group of studs nailed side by side.

Multiple studs at corners. It s not simply slamming up plywood on a stud wall. There s a lot going on in order to be structurally sound provide venting water proofing drainage insulation etc.